| Type | Redriver |
| Function | USB2 |
| USB speed (Mbps) | 480 |
| Number of channels (#) | 1 |
| Supply voltage (Max) (V) | 6.5 |
| Supply voltage (Min) (V) | 2.3 |
| Input/ouput voltage (Min) (V) | 0 |
| Input/ouput voltage (Max) (V) | 3.6 |
| Configuration | USB 2.0 Single-channel |
| Features | USB 2.0 high-speed signal conditioning , Compatible with USB 2.0, OTG 2.0 and BC 1.2 |
| Rating | Catalog |
| Operating temperature range (C) | 0 to 70 |
| ICC (Max) (uA) | 36mA |
| ESD HBM (Typ) (kV) | 2 |
| Bandwidth (MHz) | 240 |
- Wide supply voltage range: 2.3 - 6.5 V
- Ultra-low USB disconnect and shutdown power consumption
- Provides USB 2.0 high-speed signal conditioning
- Compatible with USB 2.0, OTG 2.0 and BC 1.2
- Support for low-speed, full-speed, high-speed signaling
- Integrated BC 1.2 CDP battery charging controller
- Host/Device agnostic
- Supports up to 5-m cable length
- Four selectable signal boost (edge boost along with DC boost) settings via external pull-down resistor values
- Three selectable RX sensitivity settings via pull-up-or-down to compensate ISI jitter for high-loss applications
- Supports up to 10-m cable length with two TUSB216 devices
- Scalable solution - devices can be daisy chained for high loss applications
- Pin compatible with TUSB211/212/214 (3.3V)
The TUSB216 is a third-generation USB 2.0 high-speed signal conditioner designed to compensate both AC loss (due to capacitive load) and DC loss (due to resistive loss) in the transmission channel.
The TUSB216 leverages a patented design to speed-up transition edges of USB 2.0 high-speed signal with an edge booster and increases static levels with a DC boost function. In addition, the TUSB216 includes a pre-equalization function to improve the receiver sensitivity and compensate the inter-symbol interference (ISI) jitter in application with longer cable length. USB low-speed and full-speed signal characteristics are unaffected by the TUSB216.
The TUSB216 improves signal quality without altering packet timing or adding propagation delay or latency.
The TUSB216 helps a system to pass the USB 2.0 high-speed near end eye compliance with a cable as long as 5 meters.
The TUSB216 is compatible with the USB On-The-Go (OTG) and battery charging (BC 1.2) protocols. The Integrated BC 1.2 battery charging controller can be enabled via a control pin.
